1. After the pole is installed, all the components (solar panels, batteries, light sources) are connected to the controller.

2. First, connect the filament directly to the battery line and see the light source light up, you can determine the positive and negative poles of the light source (the light source will not damage the light source if the positive and negative light sources are not connected), then connect the positive light source line to the corresponding red light bulb icon on the controller, and connect the negative light source to the controller icon on the corresponding black light bulb.

3. Use multimeter DC voltage to shift the positive and negative poles of batteries. The positive battery wire is connected to the battery icon on the controller corresponding to the red line, and the negative battery wire is connected to the black line on the battery controller.

4. Check the positive and negative poles of the solar panel with the DC voltage of the multimeter. Connect the positive line of the solar panel to the corresponding red line on the controller. Connect the negative pole of the solar panel to the controller with a solar panel corresponding to the black line.

5. The controller has been debugging the program and intelligent lighting time before leaving the factory. The wiring does not require debugging the controller. The controller will automatically enter the working state.

6. Attention: Tighten the screw when the battery box is installed, and the waterproof threading pipe. The waterproof threading pipe is inserted into the base of the pole to more than 20 cm above the ground to ensure that the pole pole pole pole pole pole poles will not be flooded to the battery frame in rainy days. In addition, the installation site should avoid obstacles to shield the solar panels, so that the solar panels can not contact the sample and can not charge.